05-06-2023, 06:00 PM
I have purchased a second hand QNAP TS-412.
(containing x4 3TB WD red drives)
How can I run the setup routine to configure this device.
I can see it in QFINDER but I have to enture it manualy as it doesn't find it on its own.
I can log into the NAZ with a browser using its i/p address and then into the admin page.
I then get this error,
System has detected that your DNS server can't resolve hosts, and some applications might not work properly.
Please go to " System Administration > Network > TCP/IP " , and check if you have entered the valid DNS server. If you are not sure what to use, please contact your ISP (Internet Service Provider) and ask for the correct information.
No matter what I do I can only get as far as this.
I have tried entering fixed i/p address's and fixed DNS but nothing works.
(containing x4 3TB WD red drives)
How can I run the setup routine to configure this device.
I can see it in QFINDER but I have to enture it manualy as it doesn't find it on its own.
I can log into the NAZ with a browser using its i/p address and then into the admin page.
I then get this error,
System has detected that your DNS server can't resolve hosts, and some applications might not work properly.
Please go to " System Administration > Network > TCP/IP " , and check if you have entered the valid DNS server. If you are not sure what to use, please contact your ISP (Internet Service Provider) and ask for the correct information.
No matter what I do I can only get as far as this.
I have tried entering fixed i/p address's and fixed DNS but nothing works.