01-04-2023, 09:14 PM
There are a few things you can try to troubleshoot the issue with your 10 GbE connection not running at full speed:
Check the cables: Make sure you are using high-quality, certified 10 GbE cables to connect the NAS and your PC. Poor quality cables can cause connectivity issues and reduced performance.
Check the MTU settings: The Maximum Transmission Unit (MTU) is the largest packet size that can be transmitted over a network. If the MTU is set too low, the packets will be fragmented, which can cause reduced performance. Try setting the MTU on both the NAS and your PC to 9000 or 9014 bytes to see if this helps.
Check the driver settings: Make sure you are using the latest driver for your 10 GbE network adapter. You can also try disabling any power-saving features in the driver settings, as these can sometimes cause performance issues.
Check the switch: If you are using a switch to connect the NAS and your PC, make sure it is a 10 GbE switch and that it is configured correctly.
Check the network configuration: Make sure the NAS and your PC are both configured for 10 GbE networking. You may need to manually configure the network settings on both devices to use the 10 GbE connection.
I hope these suggestions help!
Check the cables: Make sure you are using high-quality, certified 10 GbE cables to connect the NAS and your PC. Poor quality cables can cause connectivity issues and reduced performance.
Check the MTU settings: The Maximum Transmission Unit (MTU) is the largest packet size that can be transmitted over a network. If the MTU is set too low, the packets will be fragmented, which can cause reduced performance. Try setting the MTU on both the NAS and your PC to 9000 or 9014 bytes to see if this helps.
Check the driver settings: Make sure you are using the latest driver for your 10 GbE network adapter. You can also try disabling any power-saving features in the driver settings, as these can sometimes cause performance issues.
Check the switch: If you are using a switch to connect the NAS and your PC, make sure it is a 10 GbE switch and that it is configured correctly.
Check the network configuration: Make sure the NAS and your PC are both configured for 10 GbE networking. You may need to manually configure the network settings on both devices to use the 10 GbE connection.
I hope these suggestions help!