Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Synology M2 NVme Heat Sink

#1
Hello and I hate seagulls too!
I recently added two 800G Synology M2NVme sticks (SNV3410) to my DS923+.
You mentioned in a previous video that Synology should have catered for heat sinks for their NVmes.
Can I purchase heat sinks? If so, which heat sink would you recommend I purchase to fit the Synology NVme sticks and how should I install them?
You may actually consider turning this response into a short video because I am sure that a lot of people out there are scratching their head over this same question.
Thanks a lot and keep up the good work!
Kind regards,
Guillaume
Reply
#2
Adding heat sinks to your Synology DS923+ with the two 800GB Synology M.2 NVMe sticks (SNV3410) can be a consideration, although it's important to note that they may not significantly alter the temperature due to the lack of a dedicated fan in that area of the NAS. However, if you still wish to proceed, you can opt for a simple 5mm heat sink. Installation is relatively straightforward.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)